Connector & Socket Installation Guide

TO INSTALL: NOTE: Back and side wire accepts up to #10AWG wire

1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCULT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
   
   
2. To Side Wire: Remove insulation from each circuit conductor per strip gauge on device [approx. 3/4"(1.9cm)] . Connect wires per WIRING DIAGRAM as follows: Loop wires clockwise 3/4 turn around terminal screws. FIRMLY tighten screws over wire loops
   
   
3. To Back Wire: Remove insulation from each circuit conductor approx. 3/4"(1.9cm) Connect wires wires as per WIRING DIAGRAM as follows: Insert wires into holes next to appropriate terminal screws. Tighten screws FIRMLY
   
   
4. Mount device in wall box with screws
   
   
5. Restore power at circuit breaker or fuse
   
   

INSTALLATION IS COMPLETE